New To UFT? Join the best UFT Training Online!

Micro Focus QTP (UFT) Forums › Micro Focus UFT (earlier known as QTP) › UFT / QTP Beginners v
Problem Add Parameter Data Table

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Problem Add Parameter Data Table
aramcos81 Offline
Junior Member
**
Posts: 1
Threads: 1
Joined: Nov 2009
Reputation: 0
#1
Solved: 11 Years, 4 Months ago 02-02-2010, 07:42 PM
I would write a value to Global Sheet or Local Sheet.
If I use this command "DataTable.GlobalSheet.AddParameter "B" ,1
I don't view parameter in DataTable.
Is it correct?
Find
Reply
Saket Offline
Super Senior Member
*****
Posts: 1,199
Threads: 5
Joined: Nov 2008
Reputation: 0
#2
Solved: 11 Years, 4 Months ago 02-03-2010, 02:23 PM
whatever you do at runtime, is applicable during the run session only.
so when you add a new parameter, it is getting added at runtime, but will not be there permanently.
check your result, it must be added in the run time data table.

Find
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  data table use uft_usr 1 2,242 06-29-2016, 05:23 PM
Last Post: Ankesh
  Writing to Run time data table Neetha 5 12,175 08-27-2015, 10:18 AM
Last Post: supputuri
  Adding data into rows that add dynamically with setcelldata azar81 4 5,936 04-13-2015, 05:24 PM
Last Post: vidya2k2
  Action Parameter passing problem Qtpuser1 1 2,843 04-18-2014, 06:23 AM
Last Post: kgovadav
  Retrieving data from web table nsuresh316 1 3,112 03-03-2014, 08:29 AM
Last Post: basanth27

Forum Jump:


Users browsing this thread: 2 Guest(s)