How can I verify 2 output values equal?

[basanth27]

Assuming it is in globalsheet,

Code:

value1 = Datatable.Value("ColumnName")
value2 = Datatable.Value("ColumnName")

If Trim(value1) = Trim(value2) Then
   found = True
Else
   found = false
End if

Let me know if this helps.

[egun]

[quote='basanth27' pid='6589' dateline='1249571256']

Hi Basanth,

Yes - I feel this is good progress! I have pasted my code below, but how can I print the results somewhere? Now that I know how to check/compare these values from my website vs my database I need to be able to print them somewhere to view at the end of the run. That is the last part. I appreciate your help immensely!

Code:

DbTable("DbTable_2").Output CheckPoint("DbTable_2")
Browser("Vis").Page("Vis").WebElement("15").Output CheckPoint("TotalB")

value1 = Datatable.Value("DbTable_TBills")
value2 = Datatable.Value("_15_innertext_out")

If Trim(value1) = Trim(value2) Then
found = True
Else
found = false
End if

[basanth27]

[quote='basanth27' pid='6589' dateline='1249571256']

Hi Basanth,

Yes - I feel this is good progress! I have pasted my code below, but how can I print the results somewhere? Now that I know how to check/compare these values from my website vs my database I need to be able to print them somewhere to view at the end of the run. That is the last part. I appreciate your help immensely!

DbTable("DbTable_2").Output CheckPoint("DbTable_2")
Browser("Vis").Page("Vis").WebElement("15").Output CheckPoint("TotalB")

value1 = Datatable.Value("DbTable_TBills")
value2 = Datatable.Value("_15_innertext_out")

If Trim(value1) = Trim(value2) Then
found = True
Else
found = false
End if

You were almost there. You may have to get used on how to use QTP Help. In my view it is one of the most amazing storehouse of knowledge.

I assume you want to print the results to the QTP results, if yes this is how you do it,

Code:

DbTable("DbTable_2").Output CheckPoint("DbTable_2")
Browser("Vis").Page("Vis").WebElement("15").Output CheckPoint("TotalB")

value1 = Datatable.Value("DbTable_TBills")
value2 = Datatable.Value("_15_innertext_out")

If Trim(value1) = Trim(value2) Then
Reporter.reportevent micPass, "Value Match", "Found a Match"
Else
Reporter.reportevent micFail, "Value Match", "Values Dont Match"
End if

If you wanted to print the results somewhere other than QTP results let me know...

[egun]

That should be fine, thank you again Basanth. I had actually looked to the QTP help area after my last post and figured out how to do the same... thanks for your help.

[basanth27]

Most Welcome I request you & encourage to ask multiple questions and doubts. This is the place where we can learn and learn to share.