Hi,
I changed the "object synchronization timeout" from 20 sec to 5 sec.
I recorded a test case to insert order in flight application and ran it.
I got the error with a pop up box "Run error".
Then I started recording a new test case and added a synchronization point as shown in the screen shot. But instead of completing successfully the test completed with a warning.
Why is that?
Also can you please explain what is the use of sync point in QTP?
Regards,
Vasanthi
I changed the "object synchronization timeout" from 20 sec to 5 sec.
I recorded a test case to insert order in flight application and ran it.
I got the error with a pop up box "Run error".
Then I started recording a new test case and added a synchronization point as shown in the screen shot. But instead of completing successfully the test completed with a warning.
Why is that?
Also can you please explain what is the use of sync point in QTP?
Regards,
Vasanthi