I have configured QTP with RUMBA 7.2 by following all the instructions & steps mentioned in the QTP TE Add-In installation guide as well as the Terminal Emulator Wizard.
However, when I record the test the QTP identifies the screen as TeTextSCreen and NOT as TeScreen(there by identifying the TeField) which it ideally should because RUMBA 7.2 is supported by QTP.
However, when I record the test the QTP identifies the screen as TeTextSCreen and NOT as TeScreen(there by identifying the TeField) which it ideally should because RUMBA 7.2 is supported by QTP.