We recently upgraded to QTP/UFT 12.02 and started using the new tool.
We have an SAP program that is accessed via our SAP Portal, and when I record a script I get a script that cannot be shared with the other user of the program. And if he records a script, I cannot run it.
Here is what is recorded when I am logged in:
When the other user is logged in this is what gets recorded
We have the QTP/UFT set to use WEB and SAP add-ins.
I have attempted to change up and use different combinations of the add-ins to see if I could find a solution to our problem. No luck so far.
We log into the same PC (Where the QTP/UFT program is installed) and we have checked to see if there were different permissions or authorizations set, but we both seem to be setup the same way.
I did make a change so that when I started recording I was seeing the Browser().Page()... in the recording, but when I got down to a table view It stopped recording the screen.
Has anyone seen a similar issue with .Page and .SAPPortal?
I have been searching this wonderful forum, and the web, for over a week now. Any help or suggestions will be greatly appreciated.
We have an SAP program that is accessed via our SAP Portal, and when I record a script I get a script that cannot be shared with the other user of the program. And if he records a script, I cannot run it.
Here is what is recorded when I am logged in:
Code:
Browser("Task Management - Enterprise").SAPPortal("Task Management - Enterprise").Frame("isolatedWorkArea").SAPEdit("Task ID:").Set "1090840"When the other user is logged in this is what gets recorded
Code:
wser("Task Management - Enterprise").Page("Task Management - Enterprise").Frame("isolatedWorkArea").WebEdit("Task ID:").Set "1090840"We have the QTP/UFT set to use WEB and SAP add-ins.
I have attempted to change up and use different combinations of the add-ins to see if I could find a solution to our problem. No luck so far.
We log into the same PC (Where the QTP/UFT program is installed) and we have checked to see if there were different permissions or authorizations set, but we both seem to be setup the same way.
I did make a change so that when I started recording I was seeing the Browser().Page()... in the recording, but when I got down to a table view It stopped recording the screen.
Has anyone seen a similar issue with .Page and .SAPPortal?
I have been searching this wonderful forum, and the web, for over a week now. Any help or suggestions will be greatly appreciated.