QTP Errors

[eroshan]

Hi All

I have this problem when i try run my recording.

What can be the issue ?

[Saket]

As the error says - QTP is not able to identify the frame i.e 'center_2', make sure you are at the correct page or try to update this object in your OR.

[eroshan]

Hi

I didn't understand what you mean by 'make sure you are at the correct page'

I reset the properties of that object. but still same error

May i delete this line from Expert view ?

Thanks

[Saket]

can you paste your lines of code and snaps. of OR and if possible the application?

[eroshan]

Hi

Here i attached snaps of code and OR. Let me know if this is not enough

Highlighted error line at the code and OR shows it properties.

( I try this with temporary delete some lines including this error line , then Run went to more further steps and error occurred. error was 'Unspecified error' )

---

[Saket]

Try to highlight the "center_2" frame object. does it highlight the correct frame in your application?

[eroshan]

Hi

I think this is what you request,
The object which note by the error highlighted previously.

Thanks

[Saket]

Paste this and let me know how it goes

Code:

Browser("Browser").Page("Page").Frame("center_2").Highlight

If this does not highlight ( which i think will not work) then move the web element 'Launch..' to the frame named 'Center' in the OR
then try modifying your line

Code:

Browser("Browser").Page("Page").Frame("center").WebElement("Launch..").Click

[eroshan]

Hi
case of using this line :

Code:

Browser("Browser").Page("Page").Frame("center_2").Highlight

when i paste it at the previous line of the 8th line(which error occurs)
it gives this error

Code:

General run error.

when i paste it after that line it gives previous error

when i relapse it , it gives

Code:

General run error

I did movements what you request, then it occurs same error like this

Code:

Cannot find the "Launch CDAX Net v0.10.ßeta" object's parent "center" (class Frame). Verify that parent properties match an object currently displayed in your application.

Thanks

[Saket]

In that case I am sure you are not at the right page.
I can see at line 7, you are navigating to another page, so the page must have been changed.

try adding the object again

---

try the above statements in earlier post before line 7, it will work . if it is working then adding the object again will help.