Getting Application Error while launching Outlook

[yogesh kancherla]

Hi,
I wanted to launch Outlook with QTP code. When i am writing the below code itself its throwing Application error and QTP is getting closed

Code:

Set Outlookapp=createobject("Outlook.Application")
Set Outlookapp1=Outlookapp.GetNameSpace(

When i open braces after Getnamespace its throwing Application error and QTP is getting closed.
Please suggest where i am doing wrong?


Regards,
Yogi

[ssvali]

Try below code

Code:

Set olapp = CreateObject("Outlook.Application")
Set olns = olapp.GetNameSpace("MAPI")
olns.logon
Set objfolder=olns.getdefaultfolder(6)
objfolder.display

[yogesh kancherla]

Hi,
I copied the above code and its working but when i try to write the same its throwing application error at the below line. i am using QTP 10.0.

Code:

Set olapp = CreateObject("Outlook.Application")
Set olns = olapp.GetNameSpace(

When i use any function and open brace then application error
What might be the issue?

[krr]

May be configuration problem.