Micro Focus QTP (UFT) Forums
Unable to evaluate the expression. The debugger evaluation timeout was exceeded - Printable Version

+- Micro Focus QTP (UFT) Forums (https://www.learnqtp.com/forums)
+-- Forum: Micro Focus UFT (earlier known as QTP) (https://www.learnqtp.com/forums/Forum-Micro-Focus-UFT-earlier-known-as-QTP)
+--- Forum: UFT / QTP Beginners (https://www.learnqtp.com/forums/Forum-UFT-QTP-Beginners)
+--- Thread: Unable to evaluate the expression. The debugger evaluation timeout was exceeded (/Thread-Unable-to-evaluate-the-expression-The-debugger-evaluation-timeout-was-exceeded)



Unable to evaluate the expression. The debugger evaluation timeout was exceeded - EnthusiasticLearner - 01-07-2014

Has anyone come across this error message in QTP

Quote:Unable to evaluate the expression. The debugger evaluation timeout was exceeded
It corrupted by Debug Viewer. Searched the internet again with no help

Found the below in the HP Site but both workaround didn't work out for me for the following reasons

A. There is nothing in my watch list

B. Unable to find MicDebugView in the MicTest folder

Quote:When you use debug commands (e.g. "Step Over", "Step Into"), the evaluation of expressions in the Watch or Variables tabs of the Debug Viewer might exceed internal evaluation limits. In this case, the following message is displayed in the Debug Viewer: "Unable to evaluate the expression. The debugger evaluation timeout was exceeded."

Workaround A: Try to remove some expressions from the Watch list or simplify complex expressions and proceed with debugging.

Workaround B: Try to increase the evaluation timeout by adding the 'DbgEvalTime' registry key value. For example:

[HKEY_CURRENT_USER\Software\Mercury Interactive\QuickTest Professional\MicTest\MicDebugView] "DbgEvalTime"=dword:0000000F