+- Micro Focus QTP (UFT) Forums (https://www.learnqtp.com/forums)
+-- Forum: Micro Focus UFT (earlier known as QTP) (https://www.learnqtp.com/forums/Forum-Micro-Focus-UFT-earlier-known-as-QTP)
+--- Forum: VB Scripting/Descriptive Programming (https://www.learnqtp.com/forums/Forum-VB-Scripting-Descriptive-Programming)
+--- Thread: "Action was not found" error. What to do? (/Thread-Action-was-not-found-error-What-to-do)
"Action was not found" error. What to do? - ttralor - 03-11-2013
Hello.
I have an reusable action.
I make a "Call to existing Action" from my test.
When i run the test it works fine.
Then i close the test, open it again, and when i rum my test i got "Action was not found" error.
I also used a relative pad, but that did not help.
What i am doing wrong?
RE: "Action was not found" error. What to do? - enafeh - 05-01-2017
I have the same problem in UFT 12.53 & also in UFT 14.00.I described an action as "Reusable Action", I use this action in several tests.
in some of the tests the action in "damaged" & I get Runtime Error: Action Was Not Found.
Please help me!!!!
RE: "Action was not found" error. What to do? - Ankur - 05-04-2017
Are you using relative path? Have you ported your tests from one system to another?