+- Micro Focus QTP (UFT) Forums (https://www.learnqtp.com/forums)
+-- Forum: Micro Focus UFT (earlier known as QTP) (https://www.learnqtp.com/forums/Forum-Micro-Focus-UFT-earlier-known-as-QTP)
+--- Forum: UFT / QTP Certification UFT120-12.5-ASP (https://www.learnqtp.com/forums/Forum-UFT-QTP-Certification-UFT120-12-5-ASP)
+--- Thread: Bitmap checkpoint (/Thread-Bitmap-checkpoint--3857)
Bitmap checkpoint - tester_rahul - 10-05-2010
I have a question regarding bitmap checkpoint
If i use bitmap checkpoint for an image while recording and i change the resolution should the bitmap checkpoint pass or fail during run.
RE: Bitmap checkpoint - A.Saini - 10-06-2010
Hi Rahul,
Bitmap checkpoint is the most sensitive among all checkpoints supported by QTP. If you change the resolution, the result of bitmap checkpoint depend on the two things:
1) The QTP version you are using [advance version support for bigger range ]
2) How much change you made in resolution. [More resolution change means more probability of failure]
RE: Bitmap checkpoint - tester_rahul - 10-08-2010
I am not clear as to why this should happen. Basically the idea of bitmap checkpoint is not clear to me.
RE: Bitmap checkpoint - A.Saini - 10-08-2010
Hi Rahul,
If you really want to have good knowledge about bitmap check point you may refer QTP Help.
You will find enough details over there.
After that if you have any doubt, you can discuss here.
RE: Bitmap checkpoint - peterfernandes238 - 04-01-2011
Hi, i am new here i want to read more about this site.
=======
Peter
[ basanth ] New Post Opened under QTP suggesstions and feedback.
RE: Bitmap checkpoint - basanth27 - 04-01-2011
Thread closed.