+- Micro Focus QTP (UFT) Forums (https://www.learnqtp.com/forums)
+-- Forum: Micro Focus UFT (earlier known as QTP) (https://www.learnqtp.com/forums/Forum-Micro-Focus-UFT-earlier-known-as-QTP)
+--- Forum: UFT / QTP Beginners (https://www.learnqtp.com/forums/Forum-UFT-QTP-Beginners)
+--- Thread: QTP with RUMBA 7.2 (/Thread-QTP-with-RUMBA-7-2)
QTP with RUMBA 7.2 - AC21254 - 01-06-2009
I was configuring QTP with RUMBA 7.2 & have followed all instructions in the TE Installation guide as well as performed all stpes within the QTP Terminal Emulator wizard.
But when I start recording the test using RUMBA 7.2 it identifies the screen as TeTextScreen & NOT as TeScreen, which it ideally should (there by identifying the TeField) as RUMBA 7.2 is the supported by QTP.