How to capture the checkpoint result in the script

[geethwind]

Hi

I need to handle a situation depending on the checkpoint output.

when i have this checkpoint in the script, directly it shows the result in the results after the script is run.

Ex:

Code:

Browser("IBM WebSphere Portal").Page("IBM WebSphere Portal").Check CheckPoint("IBM WebSphere Portal_10")
Browser("IBM WebSphere Portal").Page("IBM WebSphere Portal").Check CheckPoint("IBM WebSphere Portal_11")
Browser("IBM WebSphere Portal").Page("IBM WebSphere Portal").Check CheckPoint("IBM WebSphere Portal_12")

is there anyway, i can get the result of the checkpoint captured to handle few things before the result gets prinited.

Thanks for the help.

-Geetha

[sreekanth chilam]

Hi Geetha,

Try as given below:

Code:

Chk1=Browser("IBM WebSphere Portal").Page("IBM WebSphere Portal").Check (CheckPoint("IBM WebSphere Portal_10"))
Msgbox Chk1

Chk2=Browser("IBM WebSphere Portal").Page("IBM WebSphere Portal").Check (CheckPoint("IBM WebSphere Portal_11"))
Msgbox Chk2

Chk3=Browser("IBM WebSphere Portal").Page("IBM WebSphere Portal").Check (CheckPoint("IBM WebSphere Portal_12"))
Msgbox Chk3

[basanth27]

Hi Geetha,
As a request, one of the best practices followed on the forum is to search through the existing post. We have a wonderful search functionality defined in the forum guidelines and i am pretty sure this issue was discussed several times before.

Just a suggestion. This will help you spend less time to post and wait for an answer. :-)

[NevadaMike]

I couldn't find an answer to this post and I have the same question. Can someone help or direct me?

[basanth27]

Please do not open old posts. The question raised by the questioner has been answered. Please open a new post for the question you have specific details.